ATI Technologies FireGL X3-256 Guia do Utilizador descarregar pdf (Página 13)

Quick Installation 7

CHAPTER 2:

Installing Hardware

This chapter will guide you through the physical installation of your

FireGL™ card.

Quick Installation

Experienced users and system administrators can follow these brief

instructions for installing the FireGL™ card in the shortest possible time.

To perform a quick installation

1 Uninstall the drivers and software for your old graphics card if you

have not already done so.

Note: If you are using a motherboard containing an on-board

graphics solution and do not intend to use it as part of a multiple

monitor display, disable it.

2 Shut down and disconnect your computer system.

3 Remove any previously installed card.

4 Install your new FireGL™ card.

5 Reassemble and connect your computer system.

6 Install the FireGL™ drivers and configuration software from the ATI

Installation CD-ROM by doing one of the following:

• Run through the automatic

ATISETUP utility; or

•

Start > Run > X:\ATISETUP.EXE (where X is the drive letter of

your CD-ROM drive).

Detailed Installation

The following instructions will take you step by step through the

installation of your new FireGL™.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 53 54

Sem comentários

ATI Technologies FireGL X3-256 Guia do Utilizador Página 13